top of page

Help and Advice

Listed below are some tips and links to some of our Suppliers.  If there is something you would like to see, and it's not on this page, then please drop us line and we will see if it can be included.

1.

Do I need Planning Permission?

Probably not, but on a site survey we would be able to clarify this.  You will need permission for lowering kerbs for a vehicle entrance, please see our Dropped Kerbs section on the Residential Service page for further information.

2.

3.

4.

How long does it take from order to completion?

This very much depends on the size of the job and the weather conditions. We will aim to give you an accurate timescale, but weather plays a big part in being able to carry out our services.  Rain is obviously not good, but neither is a very hot day - both will result in poor results in tarmac finishes if not managed correctly.

 

 

Can I use my new tarmac drive straightaway?

Dependant upon the job and materials used, you will be able to walk on the drive within several hours (not in stiletto’s!) and use the drive for your vehicles the next day.

 

However, hard accelerating and braking or turning the steering wheel whilst not moving should be avoided for the first week until the tarmac is thoroughly hardened.  Motorbikes should also be kept of the drive for the first week as their side or centre stands will 'dig in' to the surface.

 

Your tarmac surface may still be soft, even after 2 or 3 days - this is usually due to the weather being hot - this increases the time tarmac takes to set.  Other factors may be due to the 'cutback' additives that are included in the tarmac mix.  These are included to allow the operatives time to work the tarmac and although they increase the overall setting time, they do not effect the finished result of the drive.  If after 3 days the tarmac still remains soft and tacky, then contact us where we will endeavour to remedy the situation.

 

5.

What is involved in laying a tarmac surface?

As a guide any old surface will be removed & the ground excavated to the required depth. Edgings will be laid and secured, then generally three layers (sub-base, base & wearing course) will be laid. The number of layers and their depth is dependant on the final use required of the project.

 

What type of paving should I use?

 

As previously mentioned, paving can come in all types, colour and sizes.  If you are looking for inspiration, then why not click on the links below.  They will take you to our Suppliers brochures and may assist in your decision.  Remember we are always on hand to discuss the suitability for the project you have in mind.

bottom of page